The next item to assemble was the front axle assembly, the procedure is about the same as the rear axle assemble except for the steering knuckles. The pumpkin is off set on the front, more so that the back. When building the portals and putting the C-hubs on there’s a left & right, I saw that but still managed to get them reversed. At lest I only had to swap out one portal & the c-hubs then I was back on track. This was the 1st section where everything wasn’t in the bag as before. The drag link and steering arm are in their own bag. One end of the drag link is attached but the steering rod is not used at this time so I must be set aside for future use. This took just a bit over an hour to complete and that includes fixing the booboo.
The next bag is the chassis which looks pretty involved so I decided not and start it tonight but wait until tomorrow.