The Gmade SR03 steel beadlock wheels arrived today. The weigh 128g each so that should help lower the center of gravity some. They come with the bolts and nuts needed to assembly them along with a small lug wrench that fits a 2.5mm hex driver. There’s 2 m2.5×16 bolts included to use to clamp the beadlocks down so the lug bolts and nuts can be installed. Those are removed and replaced with the lug bolts. The first one I didn’t use locktite which is a good idea. I had to redo it. The 2nd one was not a problem. It really helps if you have another m2.5×15 bolt to use to set the nut into it’s hole. Then back it out and install the lug bolt. Got 2 assembled will do the other 2 tomorrow.